Is It Ok To Laminate Then Cut

Some people choose to cut paper items and then laminate them.

Is it ok to laminate then cut.

Simply cut the right length on a table saw then apply a bead of glue along the edge of the laminate board. If you don t want to do this you can cut laminated paper that has a sealed edge but be aware that it is no longer completely waterproof. Because your printing will be sandwiched between two pieces of laminate a 1 5 mil laminate will increase the overall thickness of your printed piece by 3 mil 003. I usually do not laminate anything but i would like to make algebra tiles.

Carefully press the wood strip in place making sure the edges are even. This can be time consuming. Then use a few small pieces of masking tape to hold the strip in place while the glue dries. This is because the laminate will have a sealed edge where one piece of the plastic laminate fused to the other.

Plus i m lazy so the thought of cutting tiny pieces carefully arranging them on a laminating sheet then re cut them out after laminating is just too much. Clamp the wood to the part of the counter that you are not cutting off. Thus laminate film measuring 1 5 mil would be 0015 thick and laminate film measuring 10 mil would be 010 thick. According to office zone if you sent your paper through when the machine was too hot sending it through the machine a second time will not fix the waviness and dimples on the surface that the excess heat caused.

I need the sides to be different colors and i don t want them to rip so i would like to laminate. In other words if you are cutting off the end of the countertop at the right hand side then clamp the wood to the left hand side of the line. But i would prefer not to cut them then glue then try and laminate all of those small pieces. First though cut the edges of the old plastic film as close the paper as you can and be sure the object is clean and dry.

In case any of the laminate chips then you can sand it away after cutting. I know that they will fall apart but i was hopeful that maybe the heat would fuse the glue or something. The material hidden below the laminate is usually wood or fiberboard that is easily cut with a drill so the challenge lies in cutting through that protective surface layer without damaging its looks.