Is A Power Strip On Carpet

Ever plug a power strip into another power strip colloquially referred to as daisy chaining.

Is a power strip on carpet.

Then install some new tack strips along the wall and staple the old padding to the new strips. Once you have the tack strips and padding in place lay the carpet back down and use a power stretcher to pull the carpet into place so it s tight. The wires inside power strips tend to be cheap and lower quality than the wires you find in your walls so when you start chaining power strips you lose a lot of electricity capacity in the process. As we mentioned routing power strips through walls is a major safety hazard because you re essentially trapping in the heat generated by the power strip which could cause a fire.

Plugging in an appliance with high power usage will heat up those low quality wires until they burst into flames. This same reasoning applies to covering your power strips or cords typically with a carpet or rug. A long power stretcher that will brace against the walls to stretch the carpeting taut across the entire room and a knee kicker that will help you push the edges into corners and over the tack strips around the perimeter of the room. Do not staple tack or tape a surge protector or power strip.

Two types of stretchers are essential to a good carpet installation. Do not locate a surge protector or power strip in any area where the unit would be covered with carpet furniture or any other item that will limit or prevent air circulation. Once the carpet is secure on the tack strips trim off the excess with a carpet cutter and you re. Doing this is a great way to short out appliances or drastically increase the risk of an electrical mishap.