Install Laminate Stair Nose Moulding

Stairnose the stairnosing is used to finish stair treads and risers which have been fully adhered to the floor using a shaw approved multipurpose flooring adhesive stop the flooring about 1 1 2 from the step s edge.

Install laminate stair nose moulding.

The molding sits against the stair tread while overlapping the front of the step to give it a nicely rounded decorative look. Things i mention in this vid. This applies to laminate stair nose as well as hardwood stair nose. Stair tread gauge http amzn to 2i3slng subscrib.

Install the molding track by gluing screwing or nailing it 3 4 from the edge of the stair tread apply construction grade adhesive to the stairnosing where the. Stair nose moldings pergo simple solution stairnose enhances the overall beauty of the staircase or step down while acting as a protective strip for the flooring along the leading edge. Length laminate stair nose molding 32 98. Wide x 94 in.

This is accomplished by cutting the riser flush with the top of the step. The main objective when cutting stair nose molding and installing it is to cut the stair nose as tight as possible to fit on each side. Zamma cross sawn oak grey 3 4 in. Installation is easy laying your laminate up to 1 3 4 from the edge of the step then cut the molding to the desired length glue screw in place in recommended.

Stair nose molding is used in conjunction with a hardwood floor installation to finish off the step or stairwell where the hardwood floor stops. And to have it set level on the edge of the stair. Stair tread and nosing installation. Thick x 2 1 8 in.

Allow time for the glue to dry by following the guidelines on the tube of glue. Installation of the stair nose trim is quick and simple with the molding held in place primarily with adhesive and a bit of additional support from wood screws. Stair nose molding is about 4 to 5 inches wide. Install the metal track on the stair nose with the liquid nails glue.