Step 1 loosen up the fibers with a pair of tweezers.
Improving burn spot on carpet.
Cut the carpet strands as long as possible so they can be attached and hide the burnt area.
Cut a few fibers from an area of the carpet that.
Cut away the burned carpet fibers using a sharp pair of scissors.
Use the tweezers to brush the fibers back against the grain plucking at them a bit to loosen them up 2 x research sourcestep 2 snip off the burnt top layer with a pair of scissors.
Then using a pair of tweezers or similar grab the strands you just cut with the tweezers and put them in the burn hole.
Go slowly and be patient as the carpet might be difficult.
This method is only suitable for small burns such as those cause by a cigarette.
Use a strong glue to stick the fibers onto the carpet to conceal the burn spot.
To help the new carpet blend in be sure the color matches and the fibers run in the same direction.
Using a piece of scrap carpet cut out an area of the carpet that is larger than the burn spot.
Vacuum any debris away.
Using a utility knife cut around the edges.
Comb the area with a wide toothed comb to restore the fibers and blend the area in with the other carpet.
Begin by sanding away burn marks with sandpaper.
Try to only cut the black or brown burnt part not the lower unaffected layer.
Cut some carpet fibers near a wall inside a cupboard or from a cut off where it won t be noticeable.
Now apply the superglue in a very small amount to the bottom of the burn hole.
Remove remaining black fibers by cutting them out with scissors.